HondaVTRSP.com

My countershaft bearing let go during the Brands Hottrax Endurance round I was going to wait till I came back from Jerez but thats the weather turning so might as well get started on it. Some tools are away to Jerez so could only get as far stripping it to the air box as you need a long Philips driver and guess what? had to go and buy another. So its right down to the engine bolts and the swing arm to come out just bought a set of axle stands to sit the pegs on I have got Harris foot peg stands but I am going to have 3 bikes all with swing arms out so need something else to help. Will start a pic diary from the next session if anyone is interested.

very interested, and looking forward to it

Go for it Neil

Pete

Got the new shaft yesterday delivered for £58 from David Silver Honda just waiting on axle stands to arrive as I will have 3 bikes on stands at one point.

Got the engine down to the clutch hub removal and the rotor removal, could anyone borrow me these special tools? I will pay postage both ways. Neil

Don't forget to order a set of gray bolts for the engine cases.
The black bolts can be re-used, but the gray bolts must be replaced each time the cases are split.
Plus they use a torque + angle method (refer to the service manual).

Hi SS yes got these, the swap is all done and only to get the oil lines for my front rad kit then it will be firing up time.
Neil